Search results

is there one out there? Comp Cams is not a option.

I wonder if GM still makes the one they used in the 700, I've read there better. The $15.00 one didn't last long.

WTB one DS only door weather strip, let me know if you can supply. 87 Buick GN. thanks.

Anyone here installed one of these in a Turbo Buick? I could use a few pointers. thanks B.

Anyone here installed one of these in a Turbo Buick? I could use a few pointers. thanks B.

No sure just where to post this but has anyone installed one of these in a TR? If so I could use some input. thanks!

Federal 3755APA and Federal 3760A have been discontinued, what's available in .721" width these days?

has to be the in line fuses going to the starter, correct?

Like the title says.. FYI the oncenter housing has a 4 bolt flange for the down pipe also 4 bolt flange to the header, Thanks.

Is there a list somewhere?

Any probleming mixing C16 with 91 with 10% ethanol (the highest octance avaiable in Maine and that's questionable at times). Am only talking 4 or 5 to one, hoping to get 93-94 octane. I've heard C16 don't mix well with ethanol blended fuels. Am running a Fast system so am not worried about a...

Is it possible for a 200-4r to shift directly from 1st to 3rd and skip 2nd gear with no flare....if so what could cause this?

Anyone have a program for 95's they would be kind enough to send me?It's a 278" motor with Champion "R" heads.Years of stored programs gone!!!!!! Updated Classic Fast. Running 91-93 with Alky. Thanks B.

need one block off plate for a T'netics 3 bolt turbine housing, fresh gasket also would be a plus. Let me know. thanks B.

are these reducers still avaiable these days? I have a speedometer here with a 145 mph face, was suppose to have been recalibrated, put it in the car, at 60 mph this thing shows about 100 on the face. Don't want to send it away again! looking for a gear reducer, have seen a few setup that way...

Has anyone done a (87 GN) head liner replacement with a ASC moon roof installed in the car? I can't find out from the vendor that supplies the Astroroof abs liner if it will work with the ASC install, are the holes in the same place. The car am working on had a butcher job of a head liner...

Have a custom TA 62mm compressor with a "P" trim turbine wheel. Have two housings a .63 garett cut for a "P" trim and a .82 T'netics . Motor is a .030 over 3.8 P&P heads, 210-215 hyd roller , 3000 stall 10" NLU 8.75 C/R Bottom end should be real strong with the Garrett but will run out of...

Have a nice one Bud! I sent you a PM on here. Did you Get that TSO-JOE Plate Yet? ;) B.

if so what years. Thanks B.

Any suggestions on doing a black out on the white line bumper strip, the TR one was all I could find. FWIW it's a new piece. thanks B.