Search results

It's been ground down slightly on the lip to clear an exhaust pipe, but didn't hurt the sealing. $100 plus shipping.

Hi all, hope you had a good Thanksgiving. Does anyone sell parts to change the 1st gear ratio of the TH700R4 or 4L60E?

I saw the shiftworks pieces, but that's way over budget. Any one do it cheaper?

I have a superior super servo that needs seals. I can get them for $21 on e-bay, but i was wondering if anyone knows what fits. The big seal is the same as stock, but the small one is the mystery. Does a seal from another trans fit it?

What are the pro's and con's of dong this. Does it cause any problems?

Looking for a shallow cast pan for 2004r, will trade a deep cast pan.

I have a deep cast pan for 2004r and I would like to trade it for a shallow cast pan.

I have for sale #1 thru #15 tab selective washers for forward drum to output shaft, several of all sizes. $2 each. I also have the steel selective washers for forward drum to hub. $8 each The sizes are as follows. .100 .101 .102 .104 .118 .120 .126 .132 .139 .148 .153 .154 .156 .162 .175...

Like the title says, where can I find new brass thrust washers for the planet gears in the 2004R? That seems to be the only part worn, the gears and bearings are all good and the steel thrust washers are ok also, just need the brass washers.

I have some wear in the contact area where the direct drum contacts the drive lugs of the sun shell. Near as I can measure, it's around .050". I can easily dress it up to take off the worn area, question is, how much is too much wear and what problems will it cause? I'm pretty sure I can put...

I bought a new normally open pressure switch and put it in the trans during rebuild, but didn't replace the lock up solenoid. Well I should have known better, the solenoid was bad and had lock up constantly. I bought a new solenoid locally from Advance BWD brand S9811 and installed it, it...

My buddy wants a 2004R in his 78 Corvette, has around 340 hp small block. The trans I found is supposed to be from an 83 Regal T type. The rear tag has the printed code gone, but on the bottom of the tag is stamped OG81 9-10 80. The valve body has BR3 ink stamped on it and the servo cover is...

Hi all, I'm new to this forum, I usually hang out over at Corvette Forum, but I have a question for the 200-4R experts here. I just rebuilt and installed the 200-4R from an 83 Cadillac Fleetwood int my 75 Corvette. I've got a couple of concerns, under heavy acceleration, I get nice high shift...