Search results

Turbine shaft walking under certain part throttle thrust loads and ringing your housing? I had a hot air actually do that and feathering the throttle would make it sound come in and out.

type o for link Fittingsandadapters.com

3/4-18 inverted flare thread. Try looking on fittingandadapters.com they have alot fittings and are very reasonable. The 1/2" tube size is 3/4-18 inverted flare. Regards, Turbo E38

IT is being slated as GNX 234 No gnx dash, no gnx turbo shield, no ladder bar pan hard rod rear suspension. Totaly bogus !!! WHAT A GUBER

Amsoil Z-rod 10W-30 Amsoil has just come out with a classic car motor oil ZRT. "amsoil Z-rod synthetic motor oil is a high-zinc formulation specially designed to prevent wear on flat tappet camshafts in classic and performance vehicles. Its propietary blend of rust and corrosion inhibitors...

Full throttle web site has been out for two days, Maintianence?

Low timing stock injector chips wanted Anybody with 91-92 octane low timing stock injector chips, please indicate if interested in selling, INSTANT PAYPAL TRANSFER of funds if intersted, Thanks, Best Regards Turbo E38

I run Sunoco (street Legal) 100 unleaded race fuel in both of my Turbo buicks, It currently is $8.25 gallon, I have Run Sunoco GT 260 plus 104 octane unleaded last summer, and I am after the speed shop to aquire two more 54 gallon drums of the stuff for me this summer. On my stock...

Robertshaw all brass balanced flow MR GASKET HAS THE ALL BRASS 54 MM unit which is a robershaw, THESE ARE BEST ! CHECK OUT ON INTERNET AND JEGS AND SUMMIT CATALOG, ALSO THE FLOWKOOLER 1621 water pump which is a modified standard pump flows better especially at lower RPMS and uses less HP at...

Check coil towers and reverse the two pairs that are not running I forgot to mention that the firing order numbers on some coil paks do not correspond to the numbers printed on the coil pak. THE original 84-85 coil tower to individual spark plug wire routing may not be the same, as when a 87...

just went through a similar situation, I got a $112 Borg warner 87 coil driver module from advance autopats, put in on the car and Code 42 pops up EST, Car runs but not right, THen I order genuine GM coil driver (ignition module) for over 225 bucks from highway stars and put it on and NO...

Wester's Garage in canada!!! Wester's Garage made me a Chip for my 1991 Buick rivera, Run 93 octane with any performance chip to get the most out of it. Check out his website, Hope that helps, YOUR 86 is A LN3 3800 ? DON'T make the same mistake I did and put in your new chip in the...

6 Things that will never happen (6) things that will never happen (1) Champion racing heads will update their website. (2) RJC Mega coil pack (3) Jay carter headers (4) More parts for the hot air cars (5) The (click here for more information , Actually has more information...

CAR now starts , IGNITION MODULE suspect This afternoon, about 2pm is the first time the shop has looked at my GN, My mechanic gets in my car and the Darn thing starts right up, With years of experience under his belt working at a Chevy/olds dealership in the past, He suggested it probably is...

T-TOP seals ? NOT sure on the T-top seals , but I do have those ill-fitting head liners installed, they have warped and curved pretty good, I do know the REAR WINDOW LEAKS BECAUSE OF RUST CANCER AROUND THE WINDOW. Wouldn't That be something if It Starts up and runs ok after being dried...

How many guys are still running Propane, GOOD IDEA BUT DID NOT CATCH ON?

Thank you, I have taken a look there and GNType Your 84 GN in the low elevens, PRETTY IMPRESSIVE !, are you running hot air set up? I would be interested in where you are injecting your alky? IS your intake manifold stock hot air or modified like a V1? I want to inject alky on my stock...

Fuel pressure was increasing with key up. Fuel rail pressure was OK and holding with very slow leak down which is normal, With RE-Start attempt, the fuel pressure did jump up, SO the pump is running for a short few seconds. I run my fuel pressure lower that normal with a diode feeding the...

Friday afternoon, I had to have my car towed home on a rollback. I just had been running it for about an hour in Ocean City, Maryland Endless summer cruise weekend, I stopped in for some of those famous Phillips Seafood lump meat crab cakes to take home to Delaware. After about a 20 minute...

best place to inject alky on stock hot air intake manifold?? I have been looking at my spare (25515926) stock intake manifold, I have all 6 bottom pipe plugs removed to take a peak inside. I was thinking of two Jets , both on the back 45 degree chamfer , one on each side of the divider...