Search results

My 87 TurboT has been out of commision for too long. 2 years ago I parked it after a hearing load knocking just above idle. I pulled the timing cover and dropped the pan and found little bits of metal. The main bearings were wearn thin, but I don't think it got the crank (I may have cought it...

I had a knocking / loud tapping sound after the car got warm. I took the timing cover off and found some wear on the cover and cam button. The strange thing is, the wear on the cover is the same diameter as the end of the cam, not the button.?? Is this normal when a cam button goes bad? Do...

Who is selling remanufactured MAF, and has anyone had good or bad experiences with them?

I blew my head gasket 8 months ago. After dealing with that, and replacing a cam due to wasting a lobe, I finally got it up and running. I broke the new cam in and everything seemed fine. I drove it about a mile the next day and everything seemed normal. Two day later it wouldn't idle and...

The wires for my MAT (stock location=air box) were pulled out of the plug. It may not matter, but could someone tell me which side the ground goes in so I can get the sensor wired correct. I'd hate to smoke the sensor or ??. Thanks,

I just got my TR back together after a blown head gasket. With a fully charged battery, I fired it up and it cranked real slow and seemed as though something was too tight. I let it run for 30 mins. I restarted it the next day and it cranked very slow again. The idle was rough and it ran...

Not a good year for the Buick.. I trashed the tranny and blew a head gasket within 6 months of each other. I appriciate the tranny shop recommendation a few months back, it worked out well. I was hoping for more good advice for a machine shop. I've desided not to have the big valves put in...

I have a TA 49 with a 2800 stall TC. I'm running the green strip 30lbs injectors. Looking for new injectors / chips for my combo. I drive the car 90 miles a day so drivability is an issue. Precision Turbo informed me that the 50lb injectors would be a good choice. I am looking at the 009s...

I'm looking for a 2004R guru in the Seattle/Bellingham area. Any suggestions??

OK, I'm convienced, I WANT ONE!! How do I contact "Steve" to place my order. I tried the link http://www.geocities.com/rad87gn/tech/SteveCkit.html with no luck. Any help would be appriciated..