Search results

it's an auto meter # 3780 , will i need to buy any thing else or is it just a quick and easy install..... thanks mike

s o l d

sent you a pm

thought i'd post up a pic and bump at the same time or make offer

i have a pair in good shape, normal sag in the center but other than that they are ok . $75 shipped to the lower 48 , if interested or want pic's let me know.

ok, after i put it at tdc , the cut out window is at 2 maybe 2 :30 not the 4 oclock it states, is that some thing to worry about ? but 2 and 4 apeer to be where it said.

how much up and down play is ok, i do have a bit if i give it a good pull..

what is or what does a broken tab look like ? i did turn it trying to help the stumble, what get's me is one day after the cap change it ran almost perfect, go out a few hours later and it started hard and realy ran like crap.. thanks for all your input

if it were june or july i would buy from one of the vendors here , as all of my other parts came from vendors here, but we are in oct. now and we'll have snow here within 4 weeks and then the car sits all winter. and i wana drive this pos now

thanks again on the write up.. i'm going with the $9 one from the parts store as i can have it tomarrow

this is a pic of mine, does every thing look ok ??

in this pic is #2 and #4 lined up they way it should be ?? or should #2 be lined up with the window ??

ok, still not sure, so should # 2 be closer to the window or the tab (#4)

no it's tight, but what tab are you talking about

connectors as in plugs that go into each other , if so i did that already... with cap off the wheel realy has no l to r play and no up or down play... as far as removing the cam sensor, by me can i wreck any thing ?? and i'll try to find a pic of cam censor to see where the roll pin is

ok let me see if i get this when you say line up #2 mark with #4 mark , but in those pic's it looks like the #4 mark lines up with the window on the brass wheel thanks

very helpfull, is there a way to tell if it's bad ??, i'm thinking it's bad as the motor seems to lift up more than i thought it used to...

i'm not following this, do i need to splice into that wire

it's not that.......................................any one

once i remove the screw will it just come off the module ??