Sir,
I have been informed to install between .006 - .007 endplay. Watch the gasket as it will compress. Mine moved about .004 after it torqued down during setup and I chased my Butt for awhile until the Board member came to my rescue.
Bob
Well it has started. The gents I bought the motor from said that it had a flat tappet cam in it. The cam or lifters did not come with the motor and I am thinking that it had a special cam/nose on the cam because I was mocking it up tonight and it appears to be offset about .100 to .120. I...
Mike,
I believe Buick used the 016 casting to produce this block as it appears that the pickup was cast into it and it has the regular oil ports in the front of the block. The next thing that I have to figure out is the pulley alignment/front bracket.
Bob
Rollie,
Do you have all the hardware and an intake for those heads? Not really sure if I have ever seen a set of 15 degree stuff and I would bet that they would require a set of custom headers. Could you post some pictures? Really interested in the exhaust ports.
Bob
Norbs,
A stock one that is welded up will fit them and I haven't tried the Edlebrock (carb unit) but have heard they will bolt on. The best one to get is the Brodix BD 90 V6 I think that is the number but I would have to go out to shop and verify that number. There are not a lot of intake...
Sir,
Nice find. I have been looking for one of those setups for YEARS!!!!!!!!! Sorry not much help on the camshaft selection. Good luck with your project.
Bob
Gents,
Working on a real one is totally involved. Every time I walk into the shop to work on mine I just walk over and cut my hand to get that out of the way. LoL
Bob