I bought an unused kit off someone however, I dont believe the wiring "pack" came with it, so I am a little stumped as to how to wiring this whole thing up. The wires comming out of the box are self explanatory, but the 4 screw type connectors are what I cant figure out. I did a search for SMC...
Please email me or post what your gains are with this setup. Im actually going to be doing the samething on my car. Will you be spraying both alky and n2o or just the n2o?
Im glad your kit is working so well. I just put mineon a couple days ago and cant wait to tune with it. I ahve the dual nozzle kit with the trunk mount 1-gallon bottle. Although our applications are a little different it should work the same
I dont see the alky causing a problem unless your getting into boost while your doing your burnout?. Another thing is that you might have your turn on point too low which will bog your engine, sounds like you need to do some more tuning there sir
Im in the process of doing this my self except i'll be putting this on a lt1 car. I would go ahead and put it on, it can only have positive affects as ther are no down sides to this setup. It will lower your iat's and allow you to increase timing or boost. Go for it!
I do not have egt guage but I do have scan master to measure knock and 02's. I dont plan on running both, I just dont know which one will yeild me the best gains, its either one or the other. Im probably going to use the alky fist and increase my timing and go from there.
Well im just trying to decide which one will give me the best results. With a 25-30 wet shot be as affective as the alky injection?. If you had the choice between the two which one would you choose?.
I will be running a ati p-600b super charger in the next three weeks. The guy im buying the kit from only has a 9lb pulley and a 12lb pulley. Since my car is stock with 10.5:1 compression I was going to start out with the 9lb pulley with the 2 core intercooler mounted in the front. I was...
Alky works very well on any force inducted application. Im goin to use it on my ati prochargered Z-28. It should work just fine with my application, the only reason im using the alky is for an extra level of protection against a blown head gasket. I do have a front mount intercooler but its...