Will fast or anyone ever develop software that can be used on a PDA for street use. Like a simple screen that shows boost-A/F-Timing etc. Or even the complete software that will run on a handheld?
Thanks for the response we are sending the box back to get all updates and check that driver. We have the harness from accel that goes from the dist to the harness there are two wires that come out of it one is hooked to a ground the other goes to the neg side of the coil.
gen vii with 2002 software......this system use to be on a mod motor....now it is on a 351 ford with 72lb inj i have no spark at all i have replaced the coil, and module...i have 12v while cranking at the coil and computer....the dashboard on the dfi shows over 100rpm while trying to crank. the...
Looking for a program to put into my gen vii It is a 351 mustand nothing fancy with dart iron heads T-76 turbo 3 bar map sensor and 72lb inj. Just looking for something that will startup and break the motor in on
yes that is my problem is clearance This is a dist that somebody recommended i am using a bank to bank setup I dont know if all of the msd pro billets and the right pickup for the FAST system
It is going into a 87 corvette Dart block
www.twinturbovette.net
somebody was showing me this dist
http://store.summitracing.com/default.asp?target=partdetail.asp&Ntt=msd%2D2345+&view=1&N=0&part=MSD%2D2345&Ntk=KeywordSearch
I am going to run a FAST system on a corvette, I am wanting to run a MSD pro billet dist. Looking for the part # of a msd dist that i can use for the crank trigger pickup. Would like to stay away from buying a crank trigger and billet dist. This is a 408 with a race harness.
Also does...
chuck it makes 15 psi at 6k it is only making about 5 psi at 3500 which the a/f goes to 12.5 on the a/f on the fast system
it has 72lb injectors it also has a weldon pump on it
fuel pressure is fine
we think the opti spark is going out again but this will be the third one was...