Recent content by kmn5

Precision PT67 DBB water cooled turbo, T4 with 3" vband turbo was used for ~5k miles then upgarded to ceramic BB's it was also rebuilt during the upgrade so basically it has ZERO miles (I have the receipt for the work) specs: compressor inlet is .75AR with 4" inlet & 3" outlet. Exhaust housing...

Thanks guys my pump should be 80-120psi it uses a progressive controller; so it should be ramping up voltage based on boost. I'll be using a M8 equivalent nozzle I was thinking about adding a flow switch, to detect when the flow stopped for whatever reason. I guess it would be safe to...

typically how many gallons per minute does a alky kit flow? (assuming I'm using a smallish size injector and it runs for the full minute) more then .1? thanks

just a though, instead of a full gauge to measure how bout just a pressure switch set at say 100psi and when it's on (at 100psi) it will light up a LED. I've seen Honeywell pressure switches go for cheap, they have a sliding tab on the side to adjust for whatever pressure to "turn on" and...

Hi all I'm looking for a set of high impedance injectors ~60 or 65lbs prefer metal tips over plastic thanks

bump make an offer

thanks :smile:

fyi forgot to mention these are turbo studs, which mount the turbo to the manifold

Hey all, got a general question. Are level8 (or class 8) engine studs strong enough? I don't have any level 10 studs on hand thanks

Hey all I'm looking for a T4 turbo with the following specs: 3" v band turbine ar lower then .78 (preferablly .63) compressor inlet of 4" and outlet of 2.5" also preferably a turbonetics (or precision, innovative, airesearch, etc) thanks

new price $65 shipped

the race chip is for high octane gas so if you ran alky you are in essance raising the octane, so I don't see why it wouldn't be compatible

bump

Selling a set of new Red Armstrong street and race chips for 50lb injectors. Still sealed in bags $75 shipped obo

bump $350 or best offer