Recent content by jerrad

Nice aluminum VC's are hard to bet.

Emailed more pics and phone number

Appreciate it man. If he want to talk I can PM you my phone number. Thanks again

I'm near Longview. About 1.5 hrs east of Dallas

I buick is more than enough for me. lol Thanks for the offer though

The car has been sitting(I have a company car) for the last year basically. About every other weekend I'll drive it to the movies but that's the extent of it. The car has 63,4xx miles. Paint is a 8.5 out of 10 and the interier is a 9 out of 10. If there are any questions ask here or you can PM...

I installed everything and fired it up. Car seems to run great but the passenger side sounds like a drum solo going off inside the valve cover. It's speeds up with rpm as usual. I've never had a roller set up, is this noise normal?

'm more worried about the ones that are kind of loose.

Guys, I installed another set of pushrods and on the driver side they all have a little resistance but still spin with my fingers. On the passenger side there are a couple that spin very freely and a couple that are pretty tight. If I start the car and the lifters pump up will this take up the...

How bad is the rust above the windshield? Any pitting or holes?

Thank you sir.

How do you get there? I turned the motor until the intake valve just started to open and measured at that point. Also, the pushrods that I installed first have about 15 miles on them and the ends are already bare metal. Does that sound like they're too long?

I'm about to measure the pushrod length and have a quick question. Does intake/exhaust valve need to be in any particular spot before I measure or does it matter? Thanks

Thank you sir. I'm going to dive into it tomorrow am and see if I can fix this turd.

I'd like to get some but I don't want to throw money at it and it not fix anything. Does anyone know if having the wrong length pushrod would cause the popping?