Recent content by gixer2

Hello all, I need to replace the fuel lines supply and return that run up the front of the engine, seems the intercooler brace rubbed a hole in the steel section of the return line so I will replace both. My question is, Has anyone done this, How much do you have to get out of the way to get...

Gn Scott, Thank You, that's exactly the advice/explanation I needed to know. Now I can order some parts and get this T running good again.

Hello to all, Just replaced stock fuel pump on my wife's daily driver 86 T type with a Delphi FE0041(stock replacement) and installed a Hot wire kit at the same time. I want to use a TT street chip in the car with some new injectors either the 42's or stock replacements like Kirbans sells. My...

Hello, I'm not 100% but that might be a broken blender door lever. You can get to it thru the glove compartment opening, it's what's supposed to move when you slide from cold to hot, you could probably feel resistance when sliding temp lever cold to hot and back. hope this helps

Hello, I had to replace the inner fenders on my wifes 86 T type and found out the inner fenders are unique to the turbo cars on both sides. I was able to get some used ones from someone's parts list.Some of the passengers side fenders get a little carved up for downpipe clearance.......

Thank You Roger, I had just posted earlier today re: size and length for gas tank lines, I can now be certain of which to buy. BTW do they all need to be fuel injection lines or just the 3/8 and 5/16? thanks, Mark

Thanks Just a Six, I didn't realize how much they wanted for the fuel injection line so I didn't want to end up with alot expensive line I won't likely need for a while. Thanks again, Mark

Hello to all, I'm getting prepared to drop the fuel tank for fuel pump replacement. My question is what length and what sizes and type of rubber line will I need if I plan on replacing all related rubber fuel lines? I do already have about 2' of 5/16 fuel injection line but I know...

I am thinking about trying the ssbc force 10 front calipers and also changing the master cylinder in an effort to improve the brakes. I am currently using a vacuum booster setup from an 85 or 86 monte carlo, it has the 11" booster. I wanted to know if anybody has tried using the corvette style...

do you have a front bumper energy absorber?

front bumper absorber Do you have a front bumper energy absorber for an 86-87 gn/t-type? If so, how much shipped to 32812? Thanks, Mark

Thanks for the reply, the one I'm looking for should measure about 5 1/2" between those points and would be under GM part #22017846. I looked up on GMpartsdirect.com and apparently the one you have and the one I'm looking for both fall in the same category but the one I mentioned above is for...

I need one good front bumper energy absorber. I will need to know the distance from bumper mounting flange (4 bolt) to the frame horn mounting flange (3 bolt). Thanks, Mark

How much for a front bumper energy absorber shipped to 32812? Thanks, Mark

Hello, I need a front bumper energy absorber, Please let me know how much shipped to 32812, Thanks, Mark