LED lights are the way to go. I'm smoked and it does show very well. Probably not the answer your looking for and some more work and cash to solve your problem.
I have gone over the timing again everything seems to be fine and still no luck.
The Cam is an ESP race grind roller cam. Sounds like my next job is not that simple...
I did get the car back from the shop still not running...it has been a little too cold to get into the car up here in Canada.
So I started again. I just replaced the Module and coil pack, picked it up from NOS4GN. It definitely required replacement when I took it apart the module was gooey...
This is the the 560hp at the rear wheels, Below are the modifications the car has.
All the help here is very much appreciated
• 3000 MILES ON THE MOTOR
• BOTH FRONT AND REAR ENDS WERE REMOVED AND REBUILT.
• ALL NEW AXEL SEALS - NEW ETON POSI-AXELS - ALL HELD TOGETHER WITH A BILLET...
Hey guys... this is one of my cars and we are getting pretty frustrated with this problem.
Bill (Anderson) you have tuned this car when it was down in Maryland, any help would be great...
cheers
jim
I have a turbo 400 with a deep pan.
Recently replaced the fluid and I Believe I have overfilled as the fluid is up the dipstick now. Bigger problem is the car wont go, I lost reverse and minimal forward action. Is this all because of too much fluid? Have I done permanent damage to the...
It does have the o-ring and I pushed it up there pretty well but who knows? If the filter has slipped this may cause the problem? I think I will be taking the pan off again. But before I do I am open to all suggstions of what to look for.
thanks
jim
I have a Turbo 400 with brake. Reverse manual. 3 speed
Doing some spring maintenance, pulled the pan off cleaned it replaced the filter, new gasket, fluid etc.
Started the vehicle for one minute shut it down, started it up agian a few minutes later put it in gear and rolled it off the...