Recent content by 1991syclone

  1. 1

    Anti-Rattle strips for T-Tops

    Got mine at Gbody, but I think several vendors sell it.
  2. 1

    Anybody buy from GN1 Performance?

    Bought several thing from him, great on help and advise. Currently getting ready to put his headers on and will report on fit. (got to get finished putting my Gbody SS T-top parts on). I was running his downpipe and wastegate which held to a quarter of a pound, until I put on the FAST XFI and...
  3. 1

    Double pumper ?

    If you have the tracking equipment you can test different turn on points for the second pump. Avoiding going over rich when the second pump kicks on. Having the second pump on all the time would only make sense if it were race only. (you are just going to be overloading the return line) The...
  4. 1

    GN Helmet

    I have searched, but can not find the vendor that made a custom Turbo helmet. Anybody know or remember them? Suggestions?
  5. 1

    Roll Cage

    Photos are great and helpful, but one question. How did you do the dash bar or does it not have one? Thanks
  6. 1

    In Development-Rear Frame Notch Kit

    My kit is on the way, I will post pictures when done (Aug). I am for the mini tub also.
  7. 1

    Jay Leno's AC

    On Jay's SBC w/TT they talked abut an elec. trunk AC unit. I have not been able to find out anything about it. Anybody know what brand or anything about it?
  8. 1

    In Development-Rear Frame Notch Kit

    I am going with the 10 Gbody GN wheels and will try the 325 or 345 drag radial. Just did not know what was an easy fit. Should I go with a different backspace?
  9. 1

    In Development-Rear Frame Notch Kit

    Just ordered my kit. How big of rims can you run, or how much space does this kit improve? Thanks
  10. 1

    HELP, Car dies when breaks are applied!

    Funny enough, mine went bad about 4 years ago and we looked at everything and finally got help from someone on the list and that was the problem. Car had no other problems, shifting or otherwise. Just every so often when I would slow down to stop the engine would load and die.
  11. 1

    HELP, Car dies when breaks are applied!

    Check what "notacarlo" said. It may be nothing but a convertor solenoid. You come to a stop and the convertor does not unlock and it stops the engine.
  12. 1

    CPT 66 Turbo???

    The car is fun as heck but I need the money right now.Anyway your 66 with the 3400 NL probably still gets triple the gas mileage of my Camaro. I would have a hard time selling the 69. I have sold too many old rides that are priced WAY too high now. Oh, for the old days of .30 a gal 110...
  13. 1

    CPT 66 Turbo???

    Yes in my opinion a 66 and a 3400 NL may not be the cheapest on gas, but like others have said. It depends on what you want to do with it. Decide that and then call Jack and trust his judgement. I am not a good example for streetability, with the adjustable 4 link it rides like a go cart...
  14. 1

    CPT 66 Turbo???

    I loved the 44, PTE exhaust, on the street (with 55 lb and a turbo tweak chip). I went to the 66 (with no other changes) and could not spin a tire. Then I went to the NL 3400 convertor and then to the FAST XFI. Now 1st and 2nd are gone so fast you better be paying attention or you'll run over...
  15. 1

    Wind noise in a t-top

    Heath, don't know if you were kidding but it sure brighten my day. You can only use duct tape, any plastic tape can make it's own noise (I can rattle your teeth with elec. tape). If you don't find noise in the t top try your moldings. Noise can come from your front windshield or even your...
Top