Weld on Ford bearing housing ends

[Pronto]

Does anyone make weld on Ford bearing housing ends to eliminate c-clips that match the G-body backing plate pattern so we could use all the stock brake stuff? I have read about the Ford "big" brake Torinos and "early" Chevy but nothing specific to the G-body. At some point in the future I will be needing to get rid of the c-clips. There seems to be alot of iffyness to the c-clip eliminators with the possibility of leaks and longevity for the street. The Ford ends look like a good way to avoid those issues especially if the stock brakes can just go back on. Anyone figure this out?

 

[novaderrik]

why would you want to keep the goofy G body bolt pattern? get the housing ends with the standard small GM pattern and pick up a set of brakes off something in the junkyard that will easily bolt up: this makes 98-02 F body rear disc brakes a bolt on deal, or maybe the bigger 11" drums off a 75-77 Monte Carlo..

 

[Pronto]

why would you want to keep the goofy G body bolt pattern?

Well, they are lighter and mine are practically brand new.