Trans +

[TRIPLEJ]

Anyone out there have any pics or advice on how to hook up the grey/white wires on the Trans +? For now, this will be an underhood hook-up. Asking questions like this makes it hard to believe I drove this thing off the showroom floor!
Thanks, J
"GO NAVY!"

 

[crownvic96]

if you bought it new it should have come with the directions. I just purchased the adapter kit from full throttle for like 80 bucks so i wouldn't have to splice into anything.

 

[pacecarta]

http://www.ramchargers.com/RamNews/Translator/buicktranslator_manual.htm


youll need to cut the est wire by the ignition module as the instructions say

the EST wire is the white wire (pin A ,first one off the firewall side) at the ignition module

 

[Morkai]

harness

If yours is still all factory condition like mine was, you'll have to remove or cut some of the covering away under the harness adapter to get to it.

 

[2QUIK6]

But as pointed out above, if you don't want to splice into any wires, get the harness, its plug-n-play. Something about cutting into the EST wire I didn't like so I never hooked mine up, and there wasn't a harness to make it plug-n-play when I bought mine.