Turbonetics T-70BB turbo with polished compressor housing, 4" inlet, 2.5" discharge, Garret .85 A/R turbine (Ptrim) with adj wastegate. It has a few passes on it and the shaft has zero play. $1200
Precision Turbo & Engine fully ported iron 8445 casting heads with 1.77/1.50 s/s valves, LT1 100# springs (for flat tappet cam), complete with keepers/retainers etc. They have been cut for receiver grooves to run the FP1007 wire loc head gaskets. These heads made a dyno calculator 714hp on my friends TTYpe with TE-63 turbo and pushed the car to 10.40's@128mph with approx 25psi. They have no problems with them at all and are ready to bolt on. $900 for the complete heads with new FP1007 head gaskets
Package (will not separate):
new 72lb injectors, LS1 MAF with Translator +, Extender Extreme chip (latest version by Bob Bailey) for 100 octane or 91/alchy injection (tuned for T-70 turbo, 72's, LS1 MAF, ported heads, 214/210 roller cam, ported intake, big intercooler/downpipe.... he can custom retune it to your combo though), new 14 guage Casper's Electronics injector harness, modified '87 GN ECM for low impedance injectors (by Bob Bailey). $1000
PTE FMIC 4.5" thick (new unused) rated at well over 900hp. Has no intercooler piping. $525
For pics... gnx7@hotmail.com
-Mark
Precision Turbo & Engine fully ported iron 8445 casting heads with 1.77/1.50 s/s valves, LT1 100# springs (for flat tappet cam), complete with keepers/retainers etc. They have been cut for receiver grooves to run the FP1007 wire loc head gaskets. These heads made a dyno calculator 714hp on my friends TTYpe with TE-63 turbo and pushed the car to 10.40's@128mph with approx 25psi. They have no problems with them at all and are ready to bolt on. $900 for the complete heads with new FP1007 head gaskets
Package (will not separate):
new 72lb injectors, LS1 MAF with Translator +, Extender Extreme chip (latest version by Bob Bailey) for 100 octane or 91/alchy injection (tuned for T-70 turbo, 72's, LS1 MAF, ported heads, 214/210 roller cam, ported intake, big intercooler/downpipe.... he can custom retune it to your combo though), new 14 guage Casper's Electronics injector harness, modified '87 GN ECM for low impedance injectors (by Bob Bailey). $1000
PTE FMIC 4.5" thick (new unused) rated at well over 900hp. Has no intercooler piping. $525
For pics... gnx7@hotmail.com
-Mark
