Just picked up a turbo car a few days ago. I knew it had a leak at the rear seal. Went to replace the seal today after dropping the pan and replacing the filter, and realize that I need the bushing replaced and I need another yoke for the shaft.
How do I remove the bushing? Is there a special tool to use? If so, where could I get one at? Is this something I can do in a garage, or should I take it to a tranny shop? When I purchased the seal, I got the set with a bushing also, but it does not seem to want to come out - easily at least.
Also, where is a good source to get a new yoke at?
Thanks all,
Mike
How do I remove the bushing? Is there a special tool to use? If so, where could I get one at? Is this something I can do in a garage, or should I take it to a tranny shop? When I purchased the seal, I got the set with a bushing also, but it does not seem to want to come out - easily at least.
Also, where is a good source to get a new yoke at?
Thanks all,
Mike
