I'm selling a set of ported M&A heads. The heads were recently checked by Champion Racing Heads and have a clean bill of health. The reason that I'm selling is I decided to go in a different direction with my car. I have owned these heads for over 6 years and they have been great performers. Disclaimer: These heads originally had valve spacing for a 4" bore. They will work on a 3.8" bore but, will require a minor bore notch on the intake side of the bore. The heads have been repaired due to dropping a valve on the number 4 cylinder. The heads were professionally checked and repaired by Champion Racing Heads.
M&A cylinder heads:
PAC-1255 Beehives install @ 1.850..200lbs will accommodate approximately .630 lift
PAC-R313 Chrome Moly retainers
Ferrea 1.9 intake and 1.6 exhaust
Crane 1.6 rockers
Crane guide plates, studs, and adjusters
One piece 9.050, 5/16 .120 wall push rods
Powder coated M&A valve covers with hardware
$1750 OBO.
M&A cylinder heads:
PAC-1255 Beehives install @ 1.850..200lbs will accommodate approximately .630 lift
PAC-R313 Chrome Moly retainers
Ferrea 1.9 intake and 1.6 exhaust
Crane 1.6 rockers
Crane guide plates, studs, and adjusters
One piece 9.050, 5/16 .120 wall push rods
Powder coated M&A valve covers with hardware
$1750 OBO.