67turboCamaro
Member
- Joined
- May 25, 2001
I am parting out a complete car minus engine and interior. The car is solid, from what I can tell there is no rust anywhere. Here is a partial list of what I have-
86-87 body parts-
Body with 6 point cage
Header panel
Headlight bezels
front bumper (GN)
87 grille
doors complete w/good power windows
front and rear glass blackout trim
fenders
hood (has some dings and center support cut out) will not ship!!
rear spoiler complete (all 5 pieces) -$250
rear bumper (GN)
Tailights
Drivetrain
Powerstroke I/C with pipes
Complete 8.5" posi rear
400 chevy transmission and 3500 converter
3.5" aluminum driveshaft for 400 trans
400 BOP switch pitch trans and converter with 1600/4000 stall, 5 miles on rebuild. (trans does need minor repair, wouldn't switch to high stall)
Centerline Autodrags- 15x3 w/ new 165 tires, and 15x8 with shot 28x10.5 slicks-$300
Misc
Gn steering column w/tilt&cruise
GN shifter
stock gas tank with welded in sump
86-87 wiring harness
driveshaft loop
radiator
MAF translator with LS1 MAF-$200
Xtender extreme chip for 83# injectors-$75
Scanmaster not sure what version, it came in a car I bought.-$200
Air bags (no hardware)-$50
Fuel sender with Walbro 340-$150
Single guage pillar pod-$15
30# injectors and Kenne Bell chip
radiator hold down- $40
Please, NO TIRE KICKERS!!
86-87 body parts-
Body with 6 point cage
Header panel
Headlight bezels
front bumper (GN)
87 grille
doors complete w/good power windows
front and rear glass blackout trim
fenders
hood (has some dings and center support cut out) will not ship!!
rear spoiler complete (all 5 pieces) -$250
rear bumper (GN)
Tailights
Drivetrain
Powerstroke I/C with pipes
Complete 8.5" posi rear
400 chevy transmission and 3500 converter
3.5" aluminum driveshaft for 400 trans
400 BOP switch pitch trans and converter with 1600/4000 stall, 5 miles on rebuild. (trans does need minor repair, wouldn't switch to high stall)
Centerline Autodrags- 15x3 w/ new 165 tires, and 15x8 with shot 28x10.5 slicks-$300
Misc
Gn steering column w/tilt&cruise
GN shifter
stock gas tank with welded in sump
86-87 wiring harness
driveshaft loop
radiator
MAF translator with LS1 MAF-$200
Xtender extreme chip for 83# injectors-$75
Scanmaster not sure what version, it came in a car I bought.-$200
Air bags (no hardware)-$50
Fuel sender with Walbro 340-$150
Single guage pillar pod-$15
30# injectors and Kenne Bell chip
radiator hold down- $40
Please, NO TIRE KICKERS!!