just installed a powerlogger and I was running through my scanmaster settings when I noticed my tps was off (.38 key on). Adjusted it to .42 then checked wot volts and could only get 3.9-.4.1 volts. Always could go to 5+ volts before and had it at 4.57 respectively. Tried the tps off my tta and same thing. Also I put my tps sensor from my ttype and put it on the tta and it was fine so its not a bad tps sensor. What the heck could change to where I cant get more than 3.9-4.1 volts wot? Only change made was I installed a powerlogger and 6.1 chip. Thanks in advance