Newbie Tuning Questions

[Rugby]

I bought the 1320 electronics Bluetooth scanner.

I noticed that the to voltage is a little low and the iac is a little high.

The car was not up to temp and the blm were high.

Should I start with the top voltage and iac or start with lowering the blm?

The car has a turbo tweak chip in it.

I attached a screen shot of the data.

 

[Rugby]

Here is a screenshot with it up to temp.

It looks like the iac drops to 29 when it warms up.

The next question is should I be able to watch the o2 to go from high to low and back to high? Or does it kinda level out because it reads all the cylinders.

 

[TurboDave]

The first pic isn't of much use because the car isn't warmed up. But the second pic shows nothing that's out of the ordinary. Oh sure, your BLM is a little high, but not maxed out, so the car should be running just fine. You could fix that by adding just a bit of fuel via your chip.
Your TPS is just a bit low though, I like to shoot for .40 to .42 with key on engine off.

 

[69RSCLONE]

Maf reading looks a little low. Mine runs around 6 at idle. Might be causing the lean BLM. What are the 3 malfunction codes?

 

[Rugby]

I am not sure they are real codes. It seems like it adds another code every time i run the program