MAT Sensor Insall

[jacksorroche]

I am currently attempting to install the MAT sensor harness from Caspers. Would anybody know the best and easiest place to route the wires through the firewall to the ECM?
All help is greatly appreciated

 

[irockwithdirt]

I made a 1" hole in my firewall just below the throttle cable and installed a rubber gromett. Made a good place to run my tach, gauge, boost too.

 

[jacksorroche]

Great idea! I drilled a hole in the same place and just filled it with silicone. The great thing about that is if I need to run more wires, I can just peal off the silcone, run the wires and full it again. Thanks for the help.