Looking for a turbo

[slamming 6]

Anybody have anything like this that will work on my car.

 

[goche4]

what are you looking for what size turbo I have a turbonetics 72/68 ball bearing

 

[slamming 6]

But will it work with my setup ie down pipe waste gate.

 

[goche4]

I have down pipe and waste gate and reworked headers ported and welded on the outside

 

[goche4]

I can get you pic of turbo Monday there is very lo miles on it and no play

 

[slamming 6]

just need the turbo.

 

[goche4]

ok t looks like it will fit look at the downpipe

 

[slamming 6]

I am just looking for a turbo not the headers and downpipe.4 bolt downpipe and waste gate on the exhaust housing.

 

[bison]

I have turbos like that. What power level?


Posted from the TurboBuick.Com mobile app

 

[slamming 6]

500-650hp.

 

[slamming 6]

Bison this is the cold air side wheel it's 69.05mm and 97.78mm.The turbo has the #6760-1-E don't know what that is.

 

[bison]

I've got a turbo that's very close to that with a cast 69 or 70mm compressor but it's got a smaller exducer than yours. Same cover and I could use any ex housing


Posted from the TurboBuick.Com mobile app

 

[slamming 6]

I've got a turbo that's very close to that with a cast 69 or 70mm compressor but it's got a smaller exducer than yours. Same cover and I could use any ex housing


Posted from the TurboBuick.Com mobile app

I could send you my exhaust housing if that will work and how much will it cost,thanks.AL.

 

[slamming 6]

Bison this is the cold air side wheel it's 69.05mm and 97.78mm.The turbo has the #6760-1-E don't know what that is.

bison what do you make of my old turbo I don't know anything about it would like to try and find out.

 

[bison]

What turbine does it have

 

[slamming 6]

Here is pictures of the turbine

 

[slamming 6]

Rough measurements but very very close just trying to ID the turbo.

 

[slamming 6]

Bison do you have any wheel shrouds for a turbonetics big shaft turbo mine was messed up when I took the turbo apart.

 

[bison]

You'd have to give me specific measurements. If it's a machined steel one I probably don't . If it's a cast one i probably do. I can make a steel one out of bar stock but it's by the hr. T-metics might have them in their catalog


Posted from the TurboBuick.Com mobile app

 

[slamming 6]

Hay Brian it's cast how much for it all.Could you make anything out on what size this turbo is I know the pictures aren't the best it's the only camera I have.