JE Stroker Pistons, locks and rings too **

[wickedtt]

I have a set of JE Forged Pistons .030 that were installed for a very short time undr 2k miles , this is a good deal for someone $400 plus shipping. Complete with pins, locks and rings..

Tanks for looking

 

[charlief1]

What pin height and stroke are they for?

 

[wickedtt]

I don't know the pin height off hand all I have written down is the bore: 3.830 used with a stroker 3.625 crank , Rods were 6.350 Pin is .927 . I beleive this is a common stroker piston used in alot of kits..

 

[charlief1]

I don't know the pin height off hand all I have written down is the bore: 3.830 used with a stroker 3.625 crank , Rods were 6.350 Pin is .940 . I beleive this is a common stroker piston used in alot of kits..

If you happen to find the pin height I may be able to use them. I've got a specific project that I need the pin height on. Thanks.

 

[wickedtt]

Ok measured the pin height to be 1.698

 

[charlief1]

Wish it would work but thanks for checking.

 

[wickedtt]

Wish it would work but thanks for checking.

No problem good luck with your project..

 

[wickedtt]

TTT

 

[wickedtt]

Will trade for a Nice SLIC

 

[SHADOWII]

What's the static c/ratio?

 

[wickedtt]

It's right where I like it 9:1

 

[wickedtt]

New price $375 plus shipping

 

[wickedtt]

To the top....

 

[SHADOWII]

It's difficult to believe no one has picked these up! I have a stock bore w/JE's, otherwise I would have taken them.

 

[wickedtt]

TTT

 

[Dlynch1130]

With that pin height it looks like a 6” connecting rod would work for a deck height of 9.51”. K1 makes a 6” rod but has a .927” wrist pin. Can you check that the .940” figure you quoted before is correct? Also do you know the volume of the dish? Thank you

 

[wickedtt]

With that pin height it looks like a 6” connecting rod would work for a deck height of 9.51”. K1 makes a 6” rod but has a .927” wrist pin. Can you check that the .940” figure you quoted before is correct? Also do you know the volume of the dish? Thank you

You are correct sir I measured it today and yes it is .927 on the wrist pin. Thanks