Just installed a rebuilt 200r4 with a Rebuilt kit and Ck front pump. What concerns me is the low TV pressure at idle. I did connect a pressure gauge and pressures are below,
Park 65 no tv and 265 full tv
Reverse 120 no tv and 265 full tv
Drive is the same as park.
Od is the same as park.
Full tv is with me pulling on the tv disconnected. Should I tighten the TV a click or two ?
The trans was built by me with parts from many vendors on this site.
The Tv is connected to a Qjet carb if that matters, but its a 1984 with the correct factory linkage.
Before I road test I would like to confirm ! Thanks
Park 65 no tv and 265 full tv
Reverse 120 no tv and 265 full tv
Drive is the same as park.
Od is the same as park.
Full tv is with me pulling on the tv disconnected. Should I tighten the TV a click or two ?
The trans was built by me with parts from many vendors on this site.
The Tv is connected to a Qjet carb if that matters, but its a 1984 with the correct factory linkage.
Before I road test I would like to confirm ! Thanks