I'm interested in making a sheetmetal intake. Can't buy one because I'm very limited in total height.
I can get an older off center tunnel ram setup for probably $75 or so to use as a starting point. What should I look for as far as plenum volume goes?
I'm thinking a short runner, large plenum setup.
For now, I'd be using GN-1's but if I was good enough at it, I'd consider the move to stage heads but I don't want to make 1500hp. I'm reasonably close to 900-1000 and really don't want to make more than 11-1200 ever. (I went through the 1/8th mile lights sideways at 123 last year because of a traction problem.) I'd do it for the looks and longevity of the motor more than anything.
(I can't wait for Jason to reply about the stage heads...)
Does anyone have any pictures of one being made in progress?
I can get an older off center tunnel ram setup for probably $75 or so to use as a starting point. What should I look for as far as plenum volume goes?
I'm thinking a short runner, large plenum setup.
For now, I'd be using GN-1's but if I was good enough at it, I'd consider the move to stage heads but I don't want to make 1500hp. I'm reasonably close to 900-1000 and really don't want to make more than 11-1200 ever. (I went through the 1/8th mile lights sideways at 123 last year because of a traction problem.) I'd do it for the looks and longevity of the motor more than anything.
(I can't wait for Jason to reply about the stage heads...)
Does anyone have any pictures of one being made in progress?