I was replacing the oil feed line and for some reason the end that goes into the motor was stuck and tried to loosen it for about a 1/2 hour. Anyways eventually I noticed the sensor moved a little bit and the piece that connects to the motor broke off!! If there is any confusion where the oil feed line and sensor attaches came off the block. How to Fix?? Can I retap it and seal it up, Then get another sensor housing piece to go into the knew tap?
Any help is appreciated (hopefully someone else has done this before:biggrin: )
Thanks
Kyle Cook
Any help is appreciated (hopefully someone else has done this before:biggrin: )
Thanks
Kyle Cook