Help with Z06 card style maf and gen 2 setup

[Dunebilly]

Hi I have the gen 2 translator hooked up and running with a 3"lt1 maf my question is I have a 4"maf sensor/maf pipe all in one that I want to use but when I tried configuring it it would not start .I tried maf input 4" mega maf and output gm stock (I think this is correct )the sensor is a card style Delphi that plugs directly to my gen 2 harness with the 5 pins I just don't know where to go next ...any input would be a blessing thanks
my chip is a tt 5.7 chip and I have sm and pl 3.0

 

[Royal-T-Ltd]

I would make sure the wires from your stock plug to the new plug/sensor are correct.... Start with the simple trouble shooting first.. Do any MAL codes show up?


Posted from the TurboBuick.Com mobile app

 

[Dunebilly]

No mal codes

 

[Royal-T-Ltd]

can you take a photo of the wiring from the stock harness until the MAF card

 

[Dunebilly]

I will do

 

[TurboBob]

check the sensor page for the input frequency.

Bob

 

[Dunebilly]

what would the target frequency need to be with that maf sensor?

 

[Dunebilly]

ok I've reset the gen 2 and tried again the settings for the 4 inch ma .... my gen 2 says its a 1.35 version my question is do I need to use a different version or is 1.35 up to date because the car will not start.. I have a tt chip in it for now and I chose gn stock maf out ...any help would be awesome

 

[Royal-T-Ltd]

What did the wiring to the adapter harness look like i never saw the pics

aaron

 

[Dunebilly]

oops i'll take them tomorrow in the day

 

[TurboBob]

1.35 is a current version number.

the 4" megamaf is what you want to choose for MAF In

what are you seeing on Freq in and Freq out?

Bob