Ok guys got the camera working so I was able to down load some pics .
Today will be the how to make the VSS and Cruz control plug and play harness. For you guys with no cruz just leave off the wiring for the Tach Convertor.
Step one:
Let’s get everything we need to build this thing. Here is a list of parts you will need and a price break down.
Tools you may not have and don’t need but make for a cleaner build
Soldering Iron, Solder and Flux (can get cheap one at wall mart) less than $20
Heat gun (got mine from harbor fright for $7 on sale)
Forceps or if you have time to order go on line and get soldering wire tinning tweezers haven’t priced these in a while but sure you can get them for under $10 Radio shack maybe
Solder suck or steel wick to remove too much solder if you have never soldered before.
Caspers electronics
102007 VDO Converter Tach Module $33
102045 VSS VDO Sender Dead End $82
102046 VSS Convertor $82
Lowes
16 gauge Primary wire 25ft roll one each black, white and red $2.50 each (or trailer wire check step 3 to explain)
2 12 packs insulated Disconnect pairs (Blade wire connectors) $1.98 each
1 9/16 x ¼ Rubber Grommet $104
Stuff I had Laying around
6in ¼ heat shrink tubing
1 ½ ft 3/8 Heat shrink tubing (I think I got all my heat shrink form harbor freight tools for like $5)
1 ft 16 gauge primary wire brown left over from a trailer lighting harness.
1 ½ in circle cut from sheet metal
Now you have everything you need let’s get ready to build this thing.