My translator has always worked fine and when I start the car everything powers up but the translator won't change value it just shows battery voltage and rpm as it would but that's all
You can try a master reset. I forget what 2 buttons but it's either the 2 on right or 2 on left.
Hold both buttons down and power up the unit. The display will say " Hold buttons to reset"
Continue to hold the buttons until display reads "all data reset". You will then need to reconfigure per your application. Good luck!
I'll have to it doesn't do a thing. I have a powerlogger I was going to send you a while ago but I bought a second one first but still have this one can i send you both? What address do I send them to