G body a/c delete panel holds ls computer

[boostified]

View attachment 273780 View attachment 273781 View attachment 273780 This is a panel I fabricated for my GN. It holds an ls computer securely in place. It is made out of 6061 aluminum, .090" thick. The cover is held in place with 6mm screws, into threaded rivet nuts. Powder coated black. Foam seal already glued on back. Only selling cause I switched to Holley efi, and it's not a good fit for that. I can make more, if there is an interest.
I can make them to fit the Holley computer inside the cabin, on the back of this plate as well. I would recommend running a catch pan for windshield run off. I have made those too, with a fitting for a drain hose as well. Asking $180.00

 

[boostified]

Offers ?

 

[proptop]

Sir,
How much just for the plate (build/new one) and would it fit a 81 Malibu?
Thanks,
Bob

 

[vader87]

I am interested. can you PM me some pics of it on the car? I appreciate you time!!

 

[boostified]

I will post some more pics in a few.

 

[boostified]

 

[boostified]

I could make plain , flat aluminum ones for $65, without powder coat.

 

[vader87]

PM sent

 

[boostified]

I could make plain , flat aluminum ones for $65, without powder coat.

And I'm pretty sure this will fit a Malibu. I cannot say for certain, but it has been my understanding that all the gbody cars share the same firewall

 

[GNBRETT]

Pretty kool