FTS RevX XR4 roller cam?

[BEATAV8]

Anyone using this roller cam? Anyone have a cam card for it?

220/224 advertised, .527/.542 gross lift. 113 LSA
I presume the lobes are 3109 and 3119 judging by the listed specs.

Considering similar specs for a stroker motor project...
3.9 bore x 3.625 stroke, race ported GN1 aluminum heads, ~10:1 compression, E85
6766 .85 3 bolt turbo
99% street driven. Quiet, simple and reliable valvetrane is a high priority. Limited travel hydraulic lifters, 1.55 rockers, and PAC-1201X springs. Due to that I'm sorta avoiding XE lobes.

 

[dank GN]

Anyone using this roller cam? Anyone have a cam card for it?

220/224 advertised, .527/.542 gross lift. 113 LSA
I presume the lobes are 3109 and 3119 judging by the listed specs.

Considering similar specs for a stroker motor project...
3.9 bore x 3.625 stroke, race ported GN1 aluminum heads, ~10:1 compression, E85
6766 .85 3 bolt turbo
99% street driven. Quiet, simple and reliable valvetrane is a high priority. Limited travel hydraulic lifters, 1.55 rockers, and PAC-1201X springs. Due to that I'm sorta avoiding XE lobes.

I was tuning there 224/224 with limited travel lifters . I loved it . The only thing was I had to send my SD2 chip back to Eric to have the target idle changed to 975-1000 rpm

 

[dank GN]

Here is my cam card

 

[BEATAV8]

Interesting... XE XFI lobes. Thanks for posting.

How high did you go in RPM with it?

 

[Boost231]

Chris's cam card doesn't appear to be the cam you have in question

Sent from my SM-G935T using Tapatalk

 

[Wahoo]

I was tuning there 224/224 with limited travel lifters . I loved it . The only thing was I had to send my SD2 chip back to Eric to have the target idle changed to 975-1000 rpm

What size engine was it installed in?

How did it idle?

I kinda want a cam like that but it sounds to be too big for most 109s?

 

[dank GN]

It was a 3.8 bored out .040 and it idled fine except I had to raise the target idle speed to 1000