Died

Jackcroisant

New Member
Joined
Apr 4, 2013
I'm in need of help, my 86 was running just fine,jump in it to go to the car wash. And made 1 little stop before I got there and she died. Would not start "crank no start" so I go get truck and trailer bring her back to the shop and she starts. But isn't running right, only code is 13 for O2 sensor. Any ideas ? Was headed to a show this weekend, but now?
 

Attachments

  • image.jpeg
    image.jpeg
    1.9 MB · Views: 56
  • image.jpeg
    image.jpeg
    1.9 MB · Views: 52
  • image.jpeg
    image.jpeg
    1.9 MB · Views: 54
fuel pump, crank sensor, cam sensor, ignition module, general wiring stuff. lots of possibilities.

do you know if you are getting injector pulses? spark? does the check engine light do its on-off-on sequence at key on?

is there no fire at all or does it catch then die?

Bob
 
I re-read your post, it starts now.

fuel pressure? stuck or bad injector? you can change the O2 sensor just for good measure, but its probably not the issue.

your tps is low and the IAC is high, but those are easily adjusted.

cam sensors are a common issue on these cars and cause all kinds of odd symptoms

B
 
the 13 could be set if tps is too high and believes car was off idle
check tps reading , maybe a bad tps sensor or it got water in it
 
So I pull the coil pack off and find this, is this a common problem or not?
 

Attachments

  • image.jpeg
    image.jpeg
    1,022 KB · Views: 84
Top