Dash Harness plug

[86Nick]

I wish Caspers would just sell the plug itself with a couple of inches of for the GNX style dash conversion. I have a Limit GNX style plate that I want to use,but need to wire it up.

 

[turbo nasty]

Maybe you cah just get the plug...give em a call

CEI - Casper's Electronics, Inc.

 

[86Nick]

Thanks, I'll try that. I'll keep my fingers crossed.

 

[dyrt]

it was listed on his front page for a while. I know for a fact because it was about 30 clams and i downloaded the installation pdf. Looks like they are trying to bank on the full conversion now which is kind of lame since it comes in at 250......good luck! I actually needed on but i already wired my setup to a molex bulkhead and soldered wires to the individual pins so i could remove it if needed. If i were doing it again this would definitely be the way to go.

 

[dyrt]

duh...should have checked the front page again. booyah..... CEI - Casper's Electronics, Inc.


this comes without wire but it has instructions. pretty simple i think.

 

[86Nick]

duh...should have checked the front page again. booyah..... CEI - Casper's Electronics, Inc.


this comes without wire but it has instructions. pretty simple i think.

Thanks, I just order one from the online store

 

[datant69]

digital conversion

i was thinking of doing a conversion, this makes it seem alot easier. does anyone know if the odometer registers if you do a conversion. i like the digital look but not sure i want to do it yet.