Cc not moving

[Darkie]

Hi guys I just finished installing a new fuel pump, hot-wire kit, 60lb injectors, alkycontrol and tt chip
The car starts and seems to idle fine but my scanmaster cc counts are no longer moving just shows 0 maybe 1 sometimes.
When hooking the hot-wire to the alternator I sparked my wrench to ground real quick by accident.
I hope I didn't fry anything I forgot to disconnect the battery.
Any ideas on how this may be resolved.
I didn't get to take the car for a ride yet
Will it need to relearn something and make my cc come back to life.
Thanks rich

 

[berserker6]

ive sparked the back of the alt once or twice myself and have been lucky. disconnect the orange wire by the battery for a few seconds, reconnect it and see if your issue clears up.

 

[Darkie]

Thanks I'll try that now

 

[Eric Stage I]

Cross Counts (CC) only happen in closed loop. So if your chip idles in open loop, you won't get any CC's.

 

[Darkie]

Wow thanks guys
It's moving now
Disconnected orange wire and let it warm up
It's moving now
My tsp is 30 and iac is 60 at idle
Is it import and that I get these into the spec shown in the scanmaster guide
I think it says about 30 for iac
Thanks again

 

[Eric Stage I]

You might find some useful info in the instructions that came with your chip.

Your CC will stop moving at idle the next time you run the car.

 

[berserker6]

if your TPS is showing 30 on the scanmaster. then yes you will want to adjust that. and until you correct that i wouldnt go beating on the car. heres a website that can assist you in making adjustments Vortex Turbo Buick Performance select BASICS on the left and look for TPS adjustment HTH

 

[Darkie]

Thanks I'm gonna get them set right in the morning then take her for an early Sunday cruise
Rich