Updated
UPDATED LIST
86/87 T Type/GN Used Parts
200r4 tranny BRF,Out of a 87 GN
Had a recent stock rebuilt, but was noisy-pulled drive shaft & tail end ball bearings came out
Shifted nicely before & during noise
Maybe all it needs is new tail shaft bearings?
Most definately good for a core if nothing else-make offer?-
SOLD
Factory Oil cooler adapter and lines-2 complete sets available-$50 ea
used-but in nice condition stock 200r4 tranny pans-$30 ea
Nice tranny inspection cover-$35
Red's Volt Booster-$35
STOCK FAN $25
STOCK T Type HEADER PANEL-Nice Condition & Orginal- $150
86 T-TYPE GRILL $25
STOCK PASS SIDE HEADER $75
RADIO FROM A 442 FITS/WORKS $25
GN CENTER CAP $10
2 REAR GN SEAT BELTS (PULL OUTS) $20 ea
FRONT FIBERGLASS BUMPER FILLER-$30
AIR DAMS $20
HEADLIGHT BEZELS- 2 CHROME-$15 ea,
FRONT TURN SIGNALS UPPER CHROME $20 ea
VDO-Competition Series Gauges 2 1/16
EGT w/Probe= $60
EGT w/o probe= $40
A Pillar Guage Holder (2 guages) matches GN Pillar-no cracks or scratches,but has alittle warpage(florida sun) but still fits great-just not of show quality (only if your very particular)
$10 w/any above gauge purchase
1 Piece Anodize UnderDrive Crankshaft Pulley -$50
Brand new 4 x 10 to 6 x 9 speaker adapters-$20
EGR Block Off Plate -power six logo-$15
S & B Filter (7") Chrome, has difuser & cone opening @ end as to being able to run a flex hose to it to pick-up more air (cold?)-fits our 3" mass air-$25
Coil Pack Bracket-$25
Stock Intercooler Brackets (2)- $50
Alternator(120 amp)-$35-
SOLD
Starter w/bolts-$25
Complete Rocker Arm Assembly(2) (Shafts/Rocker Arms)-$30
K & N 14" Filter-$25
Rear Bumperettes (2)w/rubber pads-good condition-$50
Chrome Powermaster Resevoir Lid (lightly pitted, great 5 footer) $15
OEM Timing Gears(2) & Chain-almost new(Nylon Gear-no signs of wear,no chipped teeth)-$35
EGR Vacuum Control-$35
Crank Pulley-$25
Metal Lines that start @ vacuum block & runs over to Drive Side-$35
Door Sill Plates (pair) $40
Thrasher 50 lb inj. computer chip-$25
turbo shield bracket(bolts to the head and to the turbo for the shield)-$40
Chrome/aluminum rectangle headlight retainers(4) -$25
AlkyControl Pump aka Razor- never used since refurbished(upgraded & bench tested)$100
Up Pipe(intercooler to throttle body) drilled for alky nozzle-$25
Shipping not included
Accept Paypal(add 3%)Acct=
turbobuick4@yahoo.com
FRED
