85 Buick T Type part out

[CornFed]

Havent been on the board for awhile, but picked up a wrecked 85 t type to use and build another 87 t type. Done with the car now so looking to sell off odds and ends that I didn't use. Car showed 51k miles on the dash and based in steering wheel condition I believe it.

84-85 GN / T Type steering wheel in extremely good shape. No mis coloring, twisting, etc. has one small blemish at 6 o clock-sold

84-85 Turbo that spins free and has minimal up and down shaft play. - $sold

Factory 84-85 intake, complete for the most part-$75

84-85 factory ECM; does have a "factory replacement" sticker on it-sold

84-85 factory coil-sold

84-85 valve covers -sold

2 factory crank position sensors with brackets;not sure if they both work so $30 for both

Factory fan shroud with no cracks or breaks. Overall very good condition-sold

Factory fan-$25

Car had limited upper door panelsverall good condition for a driver due to two imperfections (one on each) one side has a couple cigarette burns in one small area and other side has a small nick in the fabric;doesn't go through but is noticeable in the fabric.$125 for the uppers and lowers

Have complete set of black exterior trim so let me know if looking for something.

Also have miscellaneous engine brackets, etc if looking for something

 

[dga504]

How much for the moldings pictured?

 

[Coach]

How much for just the upper door panels?

 

[CornFed]

How much for the moldings pictured?

I can take some better pics but there is no dings in them at all. Paint isn't bad, but looks like they were repainted at one time and personally I don't think it was the best. These are the door upper moldings.
In regards to he black exterior trim, is there specific pieces you are looking for? Some have minor imperfections and I just want to make sure I give the best description of the specific pieces you might be looking for.

 

[CornFed]

How much for just the upper door panels?

$75 for the pair plus whatever shipping is

 

[Coach]

S

$75 for the pair plus whatever shipping is

Sent you a PM.
Shipping is cheapest by just sandwiching them between some cardboard and wrapping in tape. A box is too big and the oversize shipping is crazy expensive. Use the Post Office. Fed Ex will cost $100 oversize.

 

[dga504]

I need the A, B and drip rail for both sides my moldings are in bad shape.

 

[bpman1234]

How do the sunvisers look?

 

[andresfel]

do you still have the intake manifold?

Sent from my SM-N910F using Tapatalk

 

[CornFed]

Hi, yes I still have intake for sale.

Thanks

 

[andresfel]

Do you still have the intake if so what's your PayPal

Sent from my SM-N910F using Tapatalk

 

[Jared31]

Do you still have the intake if so what's your PayPal

Sent from my SM-N910F using Tapatalk

I’m looking for the passenger side a Pilar black trim that holds weather striping in

 

[Bob Lob-Law]

Are the ECM and Coil still available?

 

[CornFed]

Are the ECM and Coil still available?

I still have the ECM, but sold the coil.

 

[Bob Lob-Law]

Roger, I'll take the ECM. Do you use PayPal