8.5 Rear Fully Built For Sale

Boost231

What's An Intercooler
Staff member
Joined
May 26, 2001
I have a fully built rear end out of my car for sale. From what I can remember.

8.5
3.42
33 Spline Strange Axles
Strange Spool
C-CLIP Eliminators
Welded Axle Tubes ( terrible weld job)
Aluminum Drums
Stock Rear cover
(used ta cover on new rear)
TA stud kit for caps
1/2 studs
1350 Yoke
Less than 500 miles since new ring and pinion install
Dual Long Pads on each side

Looking for $1200 obo

Located in Phoenix at Nick Micale's
Can bring out to Socal if needed





Sent from my SM-N910T using Tapatalk
 
Last edited:
I have a fully built rear end out of my car for sale. From what I can remember.

8.5
3.42
33 Spline Strange Axles
Strange Spool
C-CLIP Eliminators
Welded Axle Tubes ( terrible weld job)
Aluminum Drums
Stock Rear cover
(used ta cover on new rear)
TA stud kit for caps
1/2 studs
1350 Yoke
Less than 500 miles since new ring and pinion install
Dual Long Pads on each side

Looking for $1200 obo

Located in Phoenix at Nick Micale's
Can bring out to Socal if needed





Sent from my SM-N910T using Tapatalk
Is this thing rough around corners?
And what are you upgrading to?
 
Never had any issues with it. Only reason I took it out was because I wanted rear disk brakes and was looking for more of a road course canyon car type car. I've had this rearend for years and lots of street miles with no leaks or issues.

Sent from my SM-N910T using Tapatalk
 
Would stock GN wheels have to be drilled for those wheel studs? I'll send a pm with my number. Make it easier to communicate.
 
Thanks Nick. I talked with Brent and came to the conclusion it would be too much rear end for my buddy. Would work great for me but I'm not ready for it yet
 
A.png
 
The meds must be getting to you Gary, this is not a sheep thread?

We can start one as it may cheer up Lou for a short while!
Oops, my bad. It's those darn drugs acting up again.

& I phrased it incorrectly, too.
Should have been:
Spare the rod & spoil the mutton "butt"on.
 
Top