3/8 maybe 5/16 wheel adapters

[asrnj77]

I'm going to run GTA rears up front and would like to use adapters rather than spacers. I tried the spacers but it doesn't seem safe enough with stock studs. The tires on 'em are 245's all around. All ready have the adapters for the rear (1.5") just need 'em for the front

 

[reed0380]

I already did this and used 7/16" thick spacers from Mr. Gasket. You must change to longer wheel studs in your front rotors or risk losing a wheel.

You also have to limit the full lock-to-lock travel of the steering wheel or you will rub the balance weights off the inside of both wheels. You need to drill and tap your lower control arm for a 5/16-18 thread and use a socket head cap screw with a jam nut to function as a positive stop.

If you can't understand what I'm referring to, you had better not do it at all.