3.59 BMS Crank For Sale

[S2V6RACER]

This is a 3.59" BMS crank. It is turned on the rods to 2.200 and .010 on the mains. The #2 rod journal was previously welded and of course this wasn't disclosed when I purchased the motor. I ran it for a couple seasons and I had it cut to 2.200 because you can't get wide journal bearings .020 under and I didn't like the way the journal looked before it was turned down. You can use BBC Chevy rods and have them machined to fit this crank.

$250.00 plus shipping

Here is a close up of #2 rod journal picture attached.

 

[S2V6RACER]

 

[BlownV6]

Ted, I will take it!! Has it been magged??? Thanks Mike

 

[S2V6RACER]

Mike,

It was not magged prior to it being turned. It has been 9.21 @ 147 and that was the last time it was ran before turned down.

 

[BlownV6]

Ted, PM answered and sent . Thanks Mike

 

[49-blues]

Ted -your mailbox is full- is your paypal address: inno51@yahoo.com so i can paypal you for the pan.