Search results

If available, I'll take the Turbo Tweak 5.6 60# race chip. Shipping to 60714 Niles, IL. Paypal ready

Is it still for sale? I will PM you. Don

Who here has ported the turbo themselves? What were your techniques for doing the job? What were your results? Since, I will be rebuilding my turbo, I decided to try porting the turbine side with a die grinder and some sanding rolls. How far into the turbine do people go. Since the cone...

Thanks for the replies. T Spool, those clamps can be found at Home Depot or any home improvement centers. They are not the perforated ones that I saw. Nice shot of your engine compartment. It looks great. Quiky One, thanks for the opinion. I was actually wondering if there may be too...

Earlier this summer, I saw a GN with intercooler clamps that had some type of perforated tube around the hoses. I really liked the look, and am trying to find a vendor with these clamps. The owner told me that they came with the car and may have been purchased through Kenne Bell since the car...

Can anybody out there answer the title question? None of my search inquiries so far have produced anything useful. To be more specific, I will be installing an '87 FWD 3.8L engine into a Fiero and would like to know if there are any aftermarket cam manufacturers for this motor. I am wondering...

Thanks for the quick responses. I am really still baffled by this problem. It really seems like a simple mechanical movement issue but may be turning into a can of worms. Nordbert, The throttle does open fully with the cable unhooked at the valve body. I removed the TV lever assembly...

I am looking for suggestions on why the TV cable on my TR is only allowing the throttle valve to open ~70% of the way. Likewise, my TPS sensor only provides a maximum of ~3.5v (this was the tip off that something was wrong at the throttle valve). When I disconnect the TV cable, the...

Has anyone installed a supercharger onto a '94 N/A 3800 regal? I have just come across a '94 S/C Olds 98 in a boneyard and was looking to install the parts onto my daily driver Regal. However, I have a few questions. Is the power steering pump the same between the 2 engines? They are at...

Does anybody have accurate (or from a known good sensor) MAF signal measurements (Hz vs. gm/sec) for the stock GN MAF sensor? I read in the service manual that the limits of the output signal should be between 32 - 150 Hz for 3 - 150 gm/sec air flow, but I may have misinterpretted this for...

Say, for dummies like me, what is a "trans+" box? Don

For alll of you out there with original TR wheels, how do you keep the center caps secured on the mag? After a run on the street, mine start to disappear. Are there any vendors selling any type of add-on-do-hickey thing that will keep them on? They are rather expensive to replace, and the...