Search results

  1. S

    1980 Buick LeSabre 4.1L $500

    This is not my car. I've been email the lady to get info on the car in hopes of finding a 350 Buick powered car. She's been patient and as helpful as could be expected so I am posting this to help her sell try and sell it. I have not seen the car in person. It's listed on the Toledo...
  3. S

    Front seal installation?

    Which side of this front seal is supposed to be facing the block? The timing cover I have is an aftermarket Silverseal HV cover. The seal is installed from the outside. If I put the seal in the way I think it supposed to go the tensioner spring will be on the outside facing the balancer. I don't...
  4. S

    M4ME Quadrajet?

    Follow up question. I found out that the carb I have is a high altitude model, 17058246. Do any of you know what the differences are between it and the normal altitude unit? Thanks,
  5. S

    Carburetor fitting?

    I'm finally starting to work on the engine for my Skyhawk and I need to take care of a few details. One problem I've ran into is that the carburetor fuel filter/inlet interferes with the thermostat housing. Does anyone know where I can get a carburetor fitting for a 78 turbo 4v that doesn't have...
  6. S

    Does this seem excessive?

    I got my block back from the machine shop and it looks like there is a lot of casting flash. If I hit this stuff with a screwdriver I can break off pieces of it. Does this look excessive. I've been inside a half dozen or so engines and never seen one this bad before. The engine was a freebee...
  7. S

    Been asked to death but...

    How do I get 9-9.5/1 compression with a 231, on the cheap?
  8. S

    Port size?

    I tried to email these questions to info@championracingheads.com, but the message bounced back. Can anybody help with this? I have a couple questions concerning the ported iron and GN1 heads. 1) What are the dimensions (Height & Width) of the exhaust port openings? I'm in the process...
  9. S

    Port size

    I tried to email these questions to info@championracingheads.com, but the message bounced back. Can anybody help with this? I have a couple questions concerning the ported iron and GN1 heads. 1) What are the dimensions (Height & Width) of the exhaust port openings? I'm in the process...
  10. S

    Carb CFM?

    Anyone know what the CFM rating of a 78 4v turbo carb is? Thanks, Mike
  11. S

    Factory Aluminum Intakes

    Was the 4.1L intake the only aluminum 4 brl factory intake for the V6?
Top