Search results

Hello, Want to upgrade/refresh the chassis/engine grounds on the TTA. Anyone know how many and approx where they are? Thanks

Hello, Anyone sell a crossmember with correct motor mounts on it? I am looking to do a hybrid. Thanks

http://www.dscr.net/ubb/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=34;t=005555

Hello, Is there a isolated way to check if ECM is good or not? Thanks

Hello, This what info I have......car died half throttle and towed home. It keeps cranking but no start, has started for half second but immediately dies. I have spark on passenger 3 wires (rules out module right?) Sparks when cranking (rules out crank sensor right?) No codes (rules out...

Hello, Car died while driving, towed home and it has sat for about a week. Tried to start today and car cranks and gives one or two start noises (pop), then keeps cranking. Unplugged crank sensor and it just cranks no start noises Car has ME-R system on it. Fueling is not the...

Drove car today and got on it a little..............car started popping and then died. Pulled over and let it sit. Tried to start again, engine turning over, then starts and just pops (engine shakes bad) and then dies. Gave it some throttle, still just pops. Any suggestions or help?? Thanks

I usually use r42lts gapped at .030, read and heard from people using an 8 or 9 cold heat range is better for turbo or nitrous cars......any comments on that??

Anyone using the "boostproof" steel gaskets? Any tricks to doing head gasket in our cars :(

Hello, Just wondering if the steel shim headgasket setup will work on a TTA??? Thanks

Want to get a pair of slicks and skinnies. Slicks are all basically 15" for 28"high. Any problems with 15"??? Any special stuff to remember such as offset or brakes? Thanks Andy

Looking to make a custom one but Spearco cores are expensive. Anyone know any sources for new cores? Thanks Andy

Hey Chris, Sorry to bother ya but please respond to email "IC tubing" when ya gots time. It's kinda urgent. Thanks :D

I purchased an AC delete bracket and one hole is bigger than the other. Bolt runs through bigger hole but other bolt cannot go through smaller hole......defective?????? This is going on a TTA. Is there a difference??? Or need to buy new bolts???

:D Anyone speak to him lately??? Thanks

Do I need to move WG if using 63 and bigger turbo???? Remember catalog saying so a long time ago...Thanks

Can anyone tell me a little about these chips? Sounds interesting VTEC for Buicks :D Thanks

I was putting a new turbo oil feed line in today and noticed this.... Our oil feed line goes into a brass block, brass block is then pushed into our block?? This block has 2 taps for 2 lines. I have looked in my TTA supplement and it states : 1. is the oil feed line into turbo and 2. is for oil...

I was putting a new turbo oil feed line in today and noticed this.... Our oil feed line goes into a brass block, brass block is then pushed into our block?? This block has 2 taps for 2 lines. I have looked in my TTA supplement and it states : 1. is the oil feed line into turbo and 2. is for oil...

For some reason, it is against motor mount and can't get line wrench around it. If I strip it, what are my options after that...:( Thanks Andy