Search results

1984 gn. What are these 2 connectors for, there just hanging around behind the glovebox?

What year Caprice?

I put 1999 GMC envoy 2 piston calipers and 1982 S10 manual brake rear wheel cylinders and because of the bigger pistons in the calipers and wheel cylinders the brake pedal is lower than usual. Which master cylinder will work with this combo, I have the monte carlo master when I changed from...

wix 51036 and buy them from rockauto i buy a case of 12 cuz i have a 89 s10 blazer also, same filter for both.

I got one with a 87 engine

nope its a 1 year interior. only for 1984

need to find the leather to recover the steering wheel.

check engine light socket 2 of them.

looking for 2 engine light sockets. they are bigger than the rest of the sockets. shipping to 60056 thanks

msd 55# to work with factory computer and turbo tweak chip on 93 octane no computer mods throttle blade has been closed for 11 years screw is resting on the arm not pushing on it.

what i have now tps .45 idle 1000 rpm park 800 in drive with foot on the brake idle control counts 0 idle 18 in drive foot on brake coolant gets to 175 degrees o2 it 2000 rpm 1.00 idle .97 and stays steady and goes up and down if gun the engine bl and int is at 128 dont go into closed loop what...

replace all vacuum lines as they might be old and crusty.

what is the thread size that goes into the engine block, for the oil pressure turbo brass block?

cork with a few dabs of rtv to hold the gasket to the valve cover only. dont poop the rtv on.

bleeding sequence right rear, left rear, right front, left front. repeat till no bubbles in the drain hose or out of bleeder screw.

got my covers from mikes montes when they first came out, got the second set. p.u.i is the company that is remaking these seat covers. back then it was 700.00 for the front seats and 1300.00 for the rear. use the old foam inserts as the new ones were to thin recovered them myself , have to...

to the top

i just didnt put a hood mat on the hood.

about 4 months ago i put my gn on the dyno and the turbo let go and oil was going into the downpipe and smoking alot. i have 75 cold and 20 hot idle presure and a booster plate. a old timer told me about putting a .060 restrictor in the oil line going to the turbo, like a carb jet seeing i have...

looking for a new brass oil block for turbo and oil pressure sender? shipping is 60056 and i have paypal.