Search results

Has anyone shimmed the rear selective washer that sets the clearance for the rear endplay? If so, what material did you use? I have some sheet aluminum that I might be able to cut and shim under the washer. I ordered some rear selective washers from a transmission parts house and they sent...

Is this the correct passage in the case to block the 3-4 accumulator feed, so that all the oil will go to the clutches (bypassing the 3-4 accumulator)? I know most shift kits use a stiffer spring or shims to limit spring travel in the 3-4 accumulator, but to totally bypass the 3-4 accumulator...

What is the function of the wavy steel in the forward clutch pack? Is it necessary for a hi perf build up? OEM is one wavy, three steels and four frictions. My rebuild kit (TCI Racing) includes four steels and four frictions for the forward clutch. By substituting some spare direct steels...

A couple of questions for Chris. In the manual on page 60, it says: "If the transmission is going to be used behind an engine that revs over 5500 rpm, a .060" bleed hole should be drilled at a 45 deg angle through the bottom of the housing as shown in figure 4B-22". Q: Is this feed hole...

Anyone have a part number for the solid teflon rings used on the input shaft and forward drum for the 200-4R? It looks like the same solid teflon ring could be used for the input shaft and/or the forward drum. The rebuild kits I have use the scarf cut rings for the input shaft. :( I would...

This question is for Bruce or Chris. I currently have a '690' pump apart during a rebuild. I pressed in a new pump bushing and modified the pump body by drilling out the drainback holes. The pump body looks good. Now I pressed in the hardened stator into the pump cover and during inspection...

Okay, So far I have been "into" three different 200-4R's. All three have chipped welds on the overrun clutch housing. None have a hole, but instead a small chunk, perhaps 1/4" long, is taken out of the weld. I have checked the overdrive carrier assembly carefully, per the CK manual...

I have been modifying a generic 200-4R governor I bought off eBay to make it like the one I removed from a MCSS 200-4R as a side project. I took measurements using a triple beam gram scale with a dial indicator accurate to 1/10th gram. Here is what I have at this point: Monte SS governor...

Hey Greg, Is this Master Racing OverHaul Kit TCI #389000 - the same stuff that is used in one of your 200-4R Street Fighter trannies? Or are the clutches more for racing? Thanks in advance