Search results

so im just cruising to work and out of no where my engine just powers down like off so i push the gas nothing im rolling in traffic not using the brakes just rolling and the engine turns on so now i pullover to check it all out and everything is fine checked my scanmaster and it didn't lose...

as of now im using a internal fuel pump out side of the tank im looking to to get a external fuel and don't know what to get i was looking at a external fuel pump that can pump 255 L\HR @ 40psi is 40psi enough????? what specs should i look fore in a external fule pump ? also...

I need some advice. I have a internal fuel pump mounted outside of tank and i don't like that the pump is sucking fuel from the tank so I was thinking about sumping the tank and that way there would always be fuel at the pump Would the internal pump be ok out side of the tank with fuel siting...

Thanks to in the elevens i got my first scan tool. Direct scan complete and works

I just installed 87 ecm tt chip 87 maf tps is at 42 fuel is at 43 psi line off plug gap at 35 it starts and idle just fine eng light is on but no code try to drive and it boggs and pops I have also replaced crank sensor and tps ,fuel punp is hot wired

looking to get some work done and can't find anyone that knows much. Dose anyone know of a shop or someone that works on gn's in las vegas

I'm trying too get a tt chip so i can run a 86/87 ecm but there is something i need too know. What is the type and part # for stock 84/85 injctors What is the stock can and spec

What is the proper plug and gap

where is the serial number and what is the casting number on a 84\85 engine block

Its finally running I put 200 miles or so hopeing 51 would go away but no luck. How to determine if it's the PROM OR COMPUTER

my wastegate solenoid is broke and i can't find a new one or even a part # can somebody help me???

As of now there is a 4 wire sensor running the car only 3 wires r being used. I want to put the right sensor on, the sensor at autozone has two slots where the brakeing points would pass through. All of my brakeing points are in line WHAT SHOULD I DO?

what is need to do to run a 86 ecm in my 85

How do I know when my computer is bad? When I turn my key on/engine off the engine light does not luminate anymore and now the car won't start.

I have an 85 grand national i'm a having a problem with my ignition control module and can not find one to replace it, can i use a 86 or 87 module??