Search results

Can anybody give me the exact fittings too convert the cooler fittings on a T-400 too AN fittings. I would assume you use either -4 or -6 braid. Any advice apppreciated.

wed. evening I ran 11.95@111.85 1.72 60' combo as follows stock shortblock stock cam t&d roller rockers champion irons & intake jay jackson TB/plenum v2 front mount stock torque con. 55# inj hot wired 307 fp this was ran on 255/50/16 BFG Drag Radials jim testa STREET chip 18-19#...

could someone please email me a copy of their direct scan disk. I have finally got the T running and it seems as though my disk has croaked, and a scan tool would be very nice. email too parts@rrohio.com thanks

anybody know the size of rear cam freeze plug? Thanks

does anybody know the part number for speed pro plasma moly rings for stock pistons

what are the best rings too use for a freshen up with stock pistons.

who makes a nice switch panel that fits cleanly in the ashtray with places for at least two switches

anybody know anything about Citgo racing fuels? We now have access too where I live for $2.99 a gallon and it is supposed too be 112 octane. I don't want too be putting junk race gas in my new motor when it is done.

Anyone know where I can get an old Accel Batch DFI manual from?

can someone please explain or send a diagram of the correct ring orientation for the LC2 :confused:

how far tore down does a motor have too be too install cam bearings. can the crank, rods, pistons, & heads stay in the motor. By the way the motor is out of the car

please venture over too the general tech section and give your input on the thread about 9/11 converters thanks

this question is probably for those whose cars see faster than 11.50. my question is who is shifting into OD. my reason for asking is the last time out I ran 11.14 at a measly 118.5 staying in D on 26x10 ET Drags. I know the car needs 28" slicks in a bad way but lets say the car has a DR on it...

can anybody here tell me what is needed too run braided tranny lines. I need too know what size line, type and size of fitttings etc are needed thanks

can anybody please explain too me what causes rich knock. thanks

anybody know anything good or bad about a place called Deltrans I think in maryland. There is what looks too be a real nice tranny for sale from a guy on this board done by them. any help would be greatly appreciated.

can you refer me too someone who can build a relatively mean 4L60-e Thanks

I need some help. I basically have 3 questions. 1. Do the valve springs on the TTA wear out as rapidly as the TR 2. Does the TTA use the same valve spring as the TR being as the TTA uses the Front wheel drive heads. 3. What the best way to change the springs. ( because the TTA doesn't...

Who makes a hot wire kit or should I say does the TTA require a hot wire such as the GN or Turbo Regal. Thanks