Search results

I have a 1986 Buick Grand National with 105,000 miles. Original paint, it is starting to crack in some places especially by upper part of door. No rust on this car at all. The floor is in excellent shape. There are some minor dents and dings on car again it is 25 years old. The interior is in...

Here are a couple of cars I found on craigslist, the first link are of two that are in need of serious work, the other is a nice driver. 1987 buick grand national Grand National 1987

Found this on Cincinnati craigslist. *****1987 GRAND NATIONAL*****

I am looking for a steering shaft / intermediate shaft from the 1995 Jeep Grand Cherokee. I got one out of a 1996 Grand Cherokee and it dose not fit. If any one has one that they want to sell I am interested. Thanks for the time.

While at work today, I observed an 87 GN that to say the least is rough. The worst of the damage is front bumper is knocked off, and a rather large dent in the passenger rear quarter. And some really nice pleather seats and some type of grey floor carpet, with no radio. Not really sure about any...

Here are a few GN's that are for sale in the Cincinnati area. Intercooled Grand National RARE -1987 BUICK REGAL 1987 Buick Grand National Turbo Charged 1987 Buick Grand National 1987 Buick Grand National

Found this in Ohio criagslist. ****BUICK GRAND NATIONAL****

Found this on Craiglist. 87 Buick GN-T type motor, trans

I found this and wanted to pass this on. It is not my car just one I found on Craigslist. =======1986 Buick Grand National....Intercooled.....4 Sale or Trade...

I was up late and was looking through Craigslist and found this for sale. Just wanted to pass it on. 90 Jeep Wrangler Turbo

I just installed a factory Casper Electronics engine harness in my 86 GN, so far every thing works fine. The fan comes on when is suppose to. The only issue is my coolant fan runs continually. Even when the temp drops down to 162 the fan is still on. I am thinking a relay is sticking but I am...

I was wondering if any one could give me an idea on how to replace #2 on the driver side. I have the rest of them done. I was thinking of removing the inner fender to get easy access, but if any one else has a better idea I am open to suggestions.