Search results

Brief history, car bought new by a female in Kansas and she sold to a collector in 04 with 27,120 miles. My friend bought it on speculation and sold it to me in 05 with 27,300 miles. It currently has 28,800 miles. It was totally stock when I purchased it, even had the original tires which have...

Mentions the TTA We Love Pontiac - History

Since I dont use the TTA much, I have been using 100 unleaded all summer. Only went through one tank this summer. Anyway, I just topped it off with 100 and am about to put it away for the winter and wont be started again til next April. Is it necessary to add Stabil or some other gas...

Just thought I would share some photos of my engine compartment after I cleaned, polished, powder coated. I have all the original parts to go back in once I decide to sell.

Since I was getting some knock at 22 lbs of boost even with Razors kit, I decided to try and add 10 gallons of Sunoco GT260 Plus to my almost empty tank. The 260 Plus is unleaded 104. I did not get any knock. I then checked Sunocos site and it seems that the GT260 (not the Plus) which is 100...

you gotta read this guys listing on EBay. Make sure you read his description and then all the questions he gets about it. Also make sure you click on Read more next to the questions to see what people are asking Factory GM SBC Deep Groove Crank Pulley 3858533 BJ L-79:eBay Motors (item...

I always worry that the contents of the inflator may not work being its been in the TTA for 20 years. Some questions: First, Anyone know if the contents (cardon dioxide I believe is what is inside) can be refilled ? Second question. I carry a small Sears tire inflator that runs off the...

eBay Motors: Pontiac : Trans Am (item 270343416020 end time Feb-18-09 14:21:24 PST)

My gas gauge is off and I need a new fuel sending unit that goes in the gas tank. Does anyone have the GM part number for it ? Second question, is this unit unique to the TTA only ? Thanks

Installed a new fuel pump today. Put the gas back in the tank that we siphoned out. Fuel gauge read 1/4 full when it should have read around 3/4. Tapped the tank and the gauge reads 3/4. Filled it up and it wont go above 3/4 full on the gauge. Needle use to read above full, but now wont...

Is there a fuse that controls the fuel pump and if so, can you please tell me where it is located ? Would like to see if thats the problem before I decide to install a new pump. Thanks

I checked Caspers and they have one listed, but is for a GN. Looks different. Any idea if its still available through GM or who may sell an aftermarket one ? Any idea what the part number is. Is the fuel pump relay the same as a regular 89 Fbody ? Thanks

In my previous post about the fuel pump no longer working, it looks like I may have to have it towed. What is the best way to have it towed so there is no damage. I was thinking of flatbedding it and have it pulled up onto the flat bed rear first ? Is there another way to get it onto the...

I installed a Walpro and hotwire kit two years ago. Car isnt used much. Got into it today, turns over but wont start. I turned the key to the on position and cant hear the fuel pump running. Before I decide that its the fuel pump gone bad. Can anyone tell me what else to look for as to...

My young son is looking at a car and would appreciate if anyone can do a carfax on the following vin 1FAFP13P2XW157420 Many thanks Bob

I decided to clean and wax the bottom of the driver and passenger doors. I found that there was two rubber plugs on each of the doors at underneath. To me it seems that these should be removed because if water gets into the door by way of the top of the door and glass, it would get trapped...

Took the TTA on a 100 mile trip to a car show, got on it once or twice and when I got to the show to detail it I found that as I cleaned the lower rear quarters on the paint was a fine film of black carbon. Trip home the same 100 miles and same results. I am running alky set at 6 on the...

I have been lucky so far and never got a flat with the TTA. I checked my spare and canister. I assume the canister is useless to inflate the spare after these years. My question is, once the spare is inflated and used, can you deflate it back to the original size so it fits back in the...

I dont have access to a parts number book and need the GM part number for the hood struts/pistons. I did a search and not sure if this number is correct 14019157 Can anyone verify that this is the GM number ? Thanks

Need to replace my hood struts. The bottom clip seems to just pop off with a screw driver. I cant seem to figure out how to get the clip off the top one so that I can remove the piston. (the one on the hood). Here is a photo of the clip I am talking about. Where I drew the red...