Search results

Flow matched 50# injectors and TT 5.5 Alky Chip less than 2k miles $180.00 Also have older 50# chips available for $30.00 each. 1. TT Alky version T5 chip 23/21 degrees timing 24-25 boost 2. Kenne Bell HLF50 22 degrees timing - no alky 3. Kenne Bell VLV 17 street chip no alky 4. Precision...

I'm looking for a known good drivers side power seat track assembly and switch. You can reply here or e-mail to skilake99@msn.com Oh yes, for a 86 - 87 GN. Thanks, Mark

New ATR 100# Valve Springs, hardened heat treated retainers and valve locks. These are new and never used - I went to bee hive springs instead. $110.00 shipped

BstC Boost Controller includes Caspers Y harness and solenoid so you can run two waste gate solenoids for a wider range of boost control.

I am upgrading the stock fuel pump on my 86 GN to a known good Walbro 340 I had laying around and just discovered that the stock fuel pump sock has a smaller diameter than the Walbro pump and will not fit. Does anyone know where I can purchase a new sock, or what vehicle the 340's were on...

I need the following parts for a new project (86 GN). 1. Gray Steering Column with tilt, cruise, delay wipers. 2. The round trim piece that goes on the bottom of the steering wheel. 3. Dash Trim that is below the steering column. 4. Front bumper cushions, 5. Shifter handle pieces - all of...

Do any of you local guys have a 86-87 IAC adaptor (stock) and the steel vacuum line set which goes on top of the throttle body for sale? I have my new motor almost complete and just realized that I am missing these pieces. Thanks, Mark

I received this information from a fellow car buff and am passing it on to others who may be affected if this new law passes. Please take the time and call the toll free number listed below and express your opinion of this ridiculous bill. What's this about you ask? Well, the Washington...

I have a machinist I have used for years doing some machine work on a motor I am building and he doesn't have a torque plate for the Buick V6's. I have searched on the internet to find one with no success. Anyone have an idea where we can rent one? Thanks

Here’s the deal. I am building a new engine for my 87 GN and I’m using cast iron ported heads with a roller cam that has a lift of .507 (at the valve), hydraulic roller lifters and roller rockers. I decided to use comp cams beehive springs part number 26918. The spec sheet calls for an installed...

I'm building a spare engine for my GN and am looking for a machine shop in the Seattle Area. I need someone who knows these engines to balance, bore, install billet main caps etc. Another question, when or at what stage is a girdle required? I would rather spend the money now if needed. I'm also...

I have been chasing a high speed / Boost problem for way too long but I think I finally have it figured out. I have changed plugs and gaped them at .032, new plug wires, checked and replaced any questionable vacuum hoses and still have the same problem. I purchased turbo link and did a few...

Anyone know where I can find the valve stem height spec's. I need to verify that I am within tollerance after a valve grind. (Stock cam and Lifters) Thanks Mark

I have my 2004r transmission down for overhaul, and my service manual calls for a special tool to measure which band apply pin to use. Is there any way to take this measurement with a dial indicator without the special tool called for? I currently have the pin with three grooves in it. Thanks...

RE: 87 Grand National BRF transmission. Is there any other way to measure which apply pin to use on the second gear band without using the special band apply measuring tools? I have all the normal mechanics tools - dial indicators dial calipers, etc. If not, does anyone know if these tools are...